If you need to reconfigure your device's communications settings, but your device is not on a LAN where you can directly access it, then you can connect a cable directly between your device and a PC/laptop.
To do this you must first know the IP address used by LAN 1:
Out of the box the device will fall back to 192.168.10.1 if it doesn't receive a DHCP address
You can have manually reconfigured it previously - if so, you must know these details to proceed.
Steps:
Power your encoder - allow it 2 minutes to power up.
Connect your PC's LAN port directly to the LAN 1 port on your device.
Reconfigure your PC's LAN port to the following settings:
IP Address: 192.168.10.10*
Subnet mask: 255.255.255.0
Gateway: leave blank
DNS: leave blank
Open your web browser and enter http://[Device IP Address]/ (so for example http://192.168.10.1/ if using the default settings). This should take you to your device's Local access mode login page.
* If you've manually assigned a static IP address already, then use another IP address in the same subnet range as the device's IP address.